This new antenna analyzer measures the complex impedance (magnitude and phase) at each frequency of interest in the range of 0.1 to 170 MHz. A PC is used to calculate several parameters, including SWR, and plot the results.
It normally has test equipment attached to the serial port, but it has a demo mode that can be ran without anything attached to the serial port.
( There is no install program. Just unzip it then run the AIM_675.exe. )
Old test results
The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results (selected in 'Test Results' table below)
What works
There is no install program. Just unzip it then run the AIM_675.exe.
The program appears but no graphics are shown.
Serial port comms appears to work OK.
What does not
The program has a graphics refresh problem. Minimising the application, then maximising it refreshes the display, but the application is still un-usable because it uses mouse over status displays that require the graphics to be constantly updated as the mouse is moved.
What was not tested
The application was not tested fully, but so far, only the graphics refresh fails to work. Once that works, other sections of the program can be tested.
