PCB Design and schematic capture application.
Also included the SPECCTRA shape based autorouter and PSPICE. Version 16.x includes the new Allegro PCB design application. OrCAD layout is still included although deprecated.
Old test results
The test results for this version are very old, and as such they may not represent the current state of Wine. Please consider submitting a new test report.
Selected Test Results (selected in 'Test Results' table below)
What works
Layout, License Manager (dosn't install, but you can copy & run from a installed version as mentioned)
What does not
Capture
What was not tested
Everything else
Additional Comments
The layout doesn't show circles. It is hard to use fine.
The OrCAD 16.5 installer requires the system-wide Owner and Organization to be set. To set these fields just open the Wine Configuration (winecfg) and go to the About tab. Once these fields are set then the installer will proceed normally.
The following comments are owned by whoever posted them. WineHQ is not responsible for what they say.
pspice
by Uwe Dippel on Friday November 2nd 2012, 5:33
Capture works fine here. (16.5)
But pspice fails, giving me an installation error at "New Simulation": I can give a Profile name, but it also requires an Inherit from an existing profile. If I put "non", a pop-up tells me about some incomplete installation; and asks me to run some binaries against the regserver: PSpiceExplorerSrvr.exe, pspice.exe, SimSrvr.exe, simmgr.exe and mrksrvr.exe.
I did all, but no change.
Before I file a bug: how can I uninstall and reinstall?
