The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results (selected in 'Test Results' table below)
What works
- Installation
{if you get the Get.MFX error you probably got to upgrade to latest Wine version from the Wine repos. In the Ubuntu 10.10 repos for example the latest is still 1.2.x}
- Some third party VST Plugins (Tested: Glitch, TS-808)
- Projects could be loaded
- Everything... :)
What does not
- Some built-in samples could not be found
- Latency is too high
- Plugin Picker is very slow
- Primary Sound Driver (use 'default', if else FL Studio won't do anything)
What was not tested
- MIDI
- All other plugins not mentioned above as working
Additional Comments
- Used default audio driver & pulse audio probably
- Not tested with WineASIO
Add Vorbis-Ogg support (I.E. Built-in drum loops and FPC ... etc.)
wine notepad 'C:\windows\system.ini' or your favorite *nix text editor
(*nix path is '~/.wine/drive_c/windows/system.ini')
...And then add this in the drivers32 section:
MSACM.vorbis=vorbis.acm
Good luck!!!
Reported fixed in wine 1.3.28 and later
The following comments are owned by whoever posted them. WineHQ is not responsible for what they say.
Loading MP3 Samples FAIL
by polyopath on Sunday November 27th 2011, 13:15
I am runnig on an archlinux up-to-date,
ALL is working fine but when i want to load mp3 samples in a "sampler" plugin by exemple, the waveform still blank and the sample can't be played.
I've trying to disable/enable "winemp3.acm" in regedit/system.ini, install ffdshow winetrick...
Can't run Wineasio
by Axelectrik on Thursday September 29th 2011, 23:58
I have followed all the steps i took before for installing the version 9.0 wich I hink are the same for 10
The problem is when I select WINEASIO as an audio driver I get a message window saying: "Error while creating the ASIO driver", after that appears another mesage window saying: "DIB cannot be made", and after that another message window saying: "Invalid pointer operation". When I try to close any of those the last message window pop-out again not allowing to use the program again, until it be killed and then opened again.
