WineHQ
Category: Main Games 1st Person Shooter Quake GLQuake 1.09 (GL 0.97)

Quake

Quake: Hardware Accelerated OpenGL Rendering

Application Details:

Version: GLQuake 1.09 (GL 0.97)
License: Retail
URL: http://www.idsoftware.com/game...
Votes: 0
Latest Rating: Platinum
Latest Wine Version Tested: 1.0.0

Maintainers: About Maintainership

No maintainers. Volunteer today!

Test Results

Old test results
The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results

What works

PLaying the missions (single player). Game has to be started with the console in the quake folder or you'll get a error saying .wad file was not found. also you need to include -nolan in your command or you'll get a "Winsock IPX bind failed". So: cd "quakefolder" wine glquake.exe -nolan

What does not

multiplayer

Workarounds

What was not tested

later levels

Hardware tested

Graphics:

  • GPU:
  • Driver:

Additional Comments

I tried to run it in kde too, but had an error saying X11 couldn't change to 16 bpp mode (even when root) It'll most likely work if you do it manually

selected in Test Results table below
Operating systemTest dateWine versionInstalls?Runs?Used
Workaround?
RatingSubmitter
ShowUbuntu 8.04 "Hardy" i386 (+ variants like Kubuntu)Jul 24 20081.0.0Yes Yes PlatinumJasmine Iwanek 
ShowUbuntu 8.04 "Hardy" i386 (+ variants like Kubuntu)Jun 02 20081.0-rc3Yes Yes PlatinumSexyBoBo 
ShowUbuntu 7.04 "Feisty" i386 (+ variants like Kubuntu)Aug 07 20070.9.42.Yes Yes GoldAndy 
CurrentUbuntu 6.10 "Edgy" i386 (+ variants like Kubuntu)Mar 24 20070.9.33.Yes Yes GoldQOLIM 

Known Bugs

Bug # Description Status Resolution Other apps affected

Show all bugs

HowTo / Notes

HOWTO: IPX Multiplayer
To get ipx network support, IPX will have to be enabled in the kernel, and you need some userspace utilities, usually called ipx-utils; and IPX must be started (there should be an initscript).

 *ubuntu users can use the commands:

sudo apt-get install ipx; sudo modprobe ipx; sudo ipx_interface add -p eth0 802.2 0x12345678

(change eth0 for the name of your ethernet/wireless card)

The frame type (802.2) needs to be equal for everyone. It is recommended to use ethernet II instead of 802.2. If playing with computers with Windows, make sure their frame type is set to what you have, and not 'automatic'. It may cause issues if you forget it.

Comments

Comments Disabled

Comments for this application have been disabled because there are no maintainers.
Back