WineHQ

Axon MultiClamp Commander 700A

One has the register using a valid serial number of the MultiClamp 700A Hardware.

The driver is only supported for WinXP 32 bit.

Application Details:

Version: 1.3.x
License: Free to use
URL: http://www.moleculardevices.co...
Votes: 0
Latest Rating: Platinum
Latest Wine Version Tested: 1.7.35

Maintainers: About Maintainership

Free Download Download

Test Results

Old test results
The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results

What works

The MC700A software can be installed and started. Demo works fine. In order to communicate with the MultiClamp 700A Hardware, the following steps were provided. Connect the Hardware with the serial interface. I've been using a Serial2USB converter, because the Laptop did not have a serial interface. The device was identified as /dev/ttyUSB0. Configure the device in wine with this command ln -s /dev/ttyUSB0 ~/.wine/dosdevices/com1 set permissions sudo chmod a+rw /dev/ttyUSB0 Afterwards, scaning for the Devicenumber in "device selection"-> "MultiClamp Hardware" -> Scan provided successfully a device number. Switching between Voltage-Clamp and Current Clamp in the software interface changed the lights on the hardware accordingly. This proofs a successful communication between the MC700A and the MultiClamp 700A.

What does not

No problems identified.

Workarounds

What was not tested

No further tests were applied

Hardware tested

Graphics:

  • GPU:
  • Driver:

Additional Comments

selected in Test Results table below
Operating systemTest dateWine versionInstalls?Runs?Used
Workaround?
RatingSubmitter
CurrentDebian GNU/Linux 7.x "Wheezy" x86_64Jan 28 20151.7.35Yes Yes PlatinumAlois Schlögl 
ShowDebian GNU/Linux 7.x "Wheezy" x86_64Mar 26 20141.7.14Yes Yes PlatinumAlois Schlögl 
ShowDebian GNU/Linux 7.x "Wheezy" x86_64Mar 26 20141.4.1Yes Yes PlatinumAlois Schlögl 

Known Bugs

Bug # Description Status Resolution Other apps affected

Show all bugs

HowTo / Notes

Using Serial2USB converter

1) Connect the Hardware with the serial interface. I've been using a Serial2USB converter, because the Laptop did not have a serial interface. The device was identified as /dev/ttyUSB0.

2) Configure the device in wine with this command

  ln -s /dev/ttyUSB0 ~/.wine/dosdevices/com1

3) Set permissions

   sudo chgrp dialout /dev/ttyUSB0

or alternatively

    sudo chmod a+rw /dev/ttyUSB0

Comments

Back