PreForm 2.14.0 - December 14, 2017
Optimized printer movement to enable faster printing
Enabled reuse of support locations after switching materials
Improved basesBetter print results
Model name on the base
Enabled manual layer navigation via the slicer slider
Improved printability displayHighlight unsupported minimas
Highlight large suction cups
New materials (Black v4, Color v1) for Form 2Black Resin FLGPBK04 (0.025, 0.05, 0.1mm)
Color Resin FLGPCB01 (0.025, 0.05, 0.1mm)
Everything, except firmware update.
Tested with Form 2 printer connected to the local network.
What does not
Firmware update was not possible, neither automatic or manual. With automatic update Preform could not connect to the printer. With manual update the firmware loaded to the printer, but the printer could not validate the firmware. Confirmed by later using a Windows computer to successfully performing a firmware update.
What was not tested
Not tested with Form 1 printer.
Not tested with USB connection to printer.
Note that Formlabs lists out-of-date graphics card drivers as a common cause for crashes (https://support.formlabs.com/h...). This was tested with an Nvidia graphics card and the following graphics drivers installed: extra/nvidia 387.34-17 and multilib/lib32-nvidia-utils 387.34-1.
|Arch Linux x86_64
|Jan 06 2018