Simulatore di Segnalamento Ferroviario

What works

• Installing the application (there will be some errors, please see the "what does not work")

• Choosing the aspect of all the signals
• Choosing a path and then setting each signal to the correct (or wrong) aspect.
• Running the test.
• Displaying your score
• Displaying and using the built-in signalling guide (you may have to arrange the two windows such that both of them are visible at the same time)
• Choosing the difficulty (beginner-intermediate-advanced)
• Changing every settings of the simulation from the "Options" windows:
  • Switch (point) maximum speed
  • Distances between signals
  • Line grade (slope)
• Using the "make the test easier" option that will highlight any wrong signals.

What does not

• During the installation of the Microsoft® MDAC® library, several errors will pop up, stating "Load library failed". However, the program will install fine and run perfectly.

Workarounds

Before installing the simulator, install MDAC using Winetricks.

What was not tested

All possible combinations of signalling. All aspects were tested and all worked fine, however.

Hardware tested

Graphics:

• GPU: AMD
• Driver: open source

Additional Comments

Gold because of the errors. If MDAC installed correctly, it would be a Platinum rating.

It also works fine in either a 64-bit or 32-bit prefix!