Orcad 10.x

Category: Main > Scientific/Technical/Math > EDA/Measurement > Orcad > 10.x

Wine Version1.7.16
Maintainers of this version:
OrCad 10.x
Old test results
The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results (selected in 'Test Results' table below)

What works


Run. (OrCAD Capture)

What does not
I can't add parts in schematic.

What was not tested
PSpice simulation.

PCB layout and routing.

Additional Comments

OrCAD is not slowdown in Wine.
But, CPU use of OrCAD is almost 100%.
I don't know. Why to do?
Test Results
DistributionTest dateWine versionInstalls?Runs?RatingSubmitter
ShowArch Linux x86_64May 30 20141.7.16 Yes Yes Gold doragasu 
ShowUbuntu 12.04 "Precise" i386 (+ variants like Kubuntu)Mar 11 20131.4 Yes Yes Bronze an anonymous user 
ShowUbuntu 9.04 "Jaunty" i386 (+ variants like Kubuntu)Apr 25 20091.1.19 Yes No Garbage an anonymous user 
ShowGentoo Linux AMD64Jun 25 20070.9.39. Yes Yes Gold an anonymous user 
CurrentFedora 7 x86_64Jun 23 20070.9.39. Yes Yes Bronze 회니 

Known bugs
Bug # Description Status Resolution Other apps affected


The following comments are owned by whoever posted them. WineHQ is not responsible for what they say.

Orcad seems to work better in 1.1.42 and above
by Jeff Carr on Thursday July 22nd 2010, 13:44
There are even some patches for the new 1.2 version (contributed in June 2010) that fix some Orcad crashes.

[post new] [reply to this]

Orcad 10.x installation (TCP/IP) error
by Indy on Sunday January 18th 2009, 5:38

I'm triying to install Orcad 10.5 under wine 1.0.1 (ubuntu 8.10+). I'm getting network failure saying something like:

Error with Network Protocols
The Network protocol installed on this computer eithre cannot be detected or are incompatible with the FLEXlm license manager.

i.e, I cannot even get to setup the license.

Anybody passed this error?


[post new] [reply to this]

Orcad 10.1
by guillermo on Tuesday January 15th 2008, 17:57
Hi all, Im installing ORcad 10.1 with Wine on debian, and the installation process takes forever, any ideas??

[post new] [reply to this]

OrCAD Place Part bug
by Jas on Tuesday November 20th 2007, 1:08
Bug 3023 from the 9.x series continues on in the 10.x series of OrCAD used under wine. Same fix applies, in wine 0.9.49, modify dlls/user32/dialog.c to exclude the line "if (hwnd ==
GetActiveWindow()) WINPOS_ActivateOtherWindow( hwnd );) " which is now on line 897 of the file at of this version.

[post new] [reply to this]

   << Back

Page loaded in 0.13591 seconds.