WineHQ

TREPCAD

this is an older version, v4 is the most up-to-date one

Application Details:

Version: 3.4.0
License: Retail
URL: http://www.trepcad.de/
Votes: 1
Latest Rating: Bronze
Latest Wine Version Tested: 1.3.19

Maintainers: About Maintainership

No maintainers. Volunteer today!

Link TREPCAD

Test Results

Old test results
The test results you have selected are very old and may not represent the current state of Wine.
Selected Test Results

What works

  • install
  • start the application
  • enter product key
  • opening a new project

What does not

  • 3D view (this apparently is a bug in the xorg driver for my specific Intel card or somewhere else in Kubuntu 11.04's graphics stack
  • stair type "1/4 gewendelt Ecke rechts" gives fatal error
  • stair type "90° mit Podest, Ecke rechts" gives fatal error
    • The fatal error reads: "Object doesn't support this property or method - frmKonstruktion.Zeichnen"

Workarounds

What was not tested

construction of a stair in its entirety

Hardware tested

Graphics:

  • GPU:
  • Driver:

Additional Comments

selected in Test Results table below
Operating systemTest dateWine versionInstalls?Runs?Used
Workaround?
RatingSubmitter
CurrentUbuntu 11.04 "Natty" i386 (+ variants like Kubuntu)May 01 20111.3.19Yes Yes NoBronzeAndreas Braml 
ShowUbuntu 10.04 "Lucid" i386 (+ variants like Kubuntu)Sep 02 20101.3.1Yes Yes NoBronzeAndreas Braml 
ShowUbuntu 10.04 "Lucid" i386 (+ variants like Kubuntu)Sep 02 20101.2Yes Yes NoSilverAndreas Braml 
ShowUbuntu 10.04 "Lucid" i386 (+ variants like Kubuntu)Jun 14 20101.2-rc3Yes Yes NoSilverAndreas Braml 
ShowUbuntu 10.04 "Lucid" i386 (+ variants like Kubuntu)Apr 23 20101.1.42Yes Yes NoSilverAndreas Braml 

Known Bugs

Bug # Description Status Resolution Other apps affected

Show all bugs

HowTo / Notes

HOWTO

I used the following steps to install the application:

  1. make sure to start with a clean WINEPREFIX, e.g. by 'rm -rf ~/.wine'
  2. get winetricks
  3. run 'sh winetricks -q vcrun6 native_oleaut32' Note: native_oleaut32 is only needed up to and including version 1.1.39 and after and including 1.3.0
  4. run 'wine msiexec /i TREPCAD\ St\ 3.4.0\ voll.msi'
  5. 'cd ~/.wine/drive_c/Programme/TREPCAD\ St\ 3/ && wine trepcad.exe'

Comments

Comments Disabled

Comments for this application have been disabled because there are no maintainers.
Back